Removal And Installation - Mazda 323 1988 Workshop Manual

STEERING GEAR AND LINKAGE 10
STEERING GEAR AND LINKAGE
REMOVAL AND INSTALLATION (2WD)
1. Loosen the front wheel lug nuts.
2. Jack up the vehicle and support it with safety stands.
3. Disconnect the battery negative cable.
4. Remove the wheels.
5. Remove the under cover.
6. Remove the parts in the sequence shown in the figure.
7. Install in the reverse order of removal.
8. After installation,, add the power steering fluid and bleed air, then check for fluid leakage.
1. Bolt
4. Return hose
2. Nut and cotter pin
(Power steering)
3. Knuckle arm/tie-rod
5. Pressure pipe
connection
(Power steering)
6. Bolts
7. Steering gear and linkage
IO-21