Mazda 323 1988 Workshop Manual page 559

7c
ASSEMBLY
Drive pinion model
\ / Scacer
*Bearing inner
1
I
83UO7CJx
12
3
83uo7c.o*4
6. Install the bearing inner race, companion flange,
washer, nut and the
SST
to the drive pinion model.
Note
a) Use the nut which was removed.
b)Tighten the nut enough so that the drive
pinion model can still be turned by hand.
7. Place the
SST
on the surface plate and set the dial
indicator to "Zero".
8. Set the
SST
on top of the gauge block.
9. Place the measure probe of the dial indicator so
that it contacts the area where the side bearing is
installed in the carrier, and measure the lowest po-
sition. Measure both the left and the right sides.
70-52