Mazda 323 1988 Workshop Manual page 502

?A
INSTALLATION
INSTALLATION
Install in the reverse order of removal and be careful
of the following:
Transaxle
Apply a thin coat molybdenum disulphide grease to
the spine of the primary shaft geat. Tighten the trans-
axle mounting bolts to the specified torque.
Tightening torque:
Upper bolts
63-69 N.m (6.5-9.1 m-kg, 47-66 ft-lb)
Lower bolts
63-69 N.m (6.6-9.1 m-kg, 47-66 ft-lb)
Starter
Tighten the starter to the specified torque.
Tightening torque:
31-46 N.m (3.2-4.7 m-kg, 23-34 ft-lb)
Extension Bar and Change Control Rod
Install the extension bar and the change control rod,
and tighten them to the specified torque.
Tightening torque
Extension bar:
31-46 N.m (3.2-4.7 m-kg, 23-34 ft-lb)
Change control rod:
16-22 N-m (1.6-2.3 m-kg, 12-17 ft-lb)
Crossmember
After tightening the eingine mountion rubber No. 2
bracket to the transaxle, install the crossmember and
tighten to the specified torque.
Tightening torque
No. 2 bracket:
37-62 N .m (3.6-5.3 m-kg, 27-36 ft-lb)
A:
64-99
N.m
(6.5-9.1 m-kg, 47-66 Mb)
B: 26-46 N.m
(2.9-4.7 m-kg, 2044 ft-lb)
7A-78