ALTERNATOR
5
BFb
(rear&j
+an (front)
63UO5X-991
1. Place a soldering
iron (200W
class) on the bear-
ing box for
3 or 4 minutes
and heat hit to about
50-6O'C
(122 & 140°F).
Next, pull out the three bolts, and then insert a flat-
tip screwdriver
between the stator and front bracket
and separate
them.
Note
a) If the bearing box is not heated, the bear-
ing cannot be pulled out, because the rear
bearing and rear bracket
fit together
very
tightly.
b) Be careful not to force the screwdriver
in
too far, because
the stator
may become
scratched.
2. Separate
the rear and front sections.
Note
Be careful not to lose the stopper spring that
fits around
the circumference
of the rear
bearing.
3. Place the rotor in a vise and loosen the pulley nut,
then
disassemble
the
pulley,
rotor
and
front
housing.
5-15