9
DRIVESHAFT
Differential
side
Wheel side
ASSEMBLY (Non-Turbo)
Assemble in the reverse order of disassembly and
note the following:
Boot
The shape of the ball joint boots at the wheel side
and the differential side differ, so be careful not to in-
stall incorrectly.
@: 83.8 mm (2.39 in)
@: 90.4 mm (3.56 in)
T&pod
Joint
1. Before inserting the boot onto the shaft put tape
on the shaft splines.
2. Align the matching marks and install the Vi-pod joint
with a rod and a hammer.
3. Install the snap ring with snap ring pliers
Matching
marks
53"09X-05
4. Apply the specified grease (lithum) to the joint. Do
not use any other type of grease.
Note
The color of this grease is yellow, and it Is sup-
plled in the boot kit and joint kit.
9-20
323 Revised IO/87