Mazda 323 1988 Workshop Manual page 846

14
FRONT WINDOW GLASS
B-B section
INSTALLATION
1, Use a knife to smoothly trim the sealant on the
body. Leave a layer about
1 or 2 mm (0.04 to
0.08
in)
thick.
Caution
If some sealant flakes off, use new sealant to
patch it.
2. Carefully clean and remove any grease from a 5
cm (1.97 in)
wide area around the circumference
of the glass and the remaining bond on the body.
3. Bond a dam along the circumference of the glass
5
mm
(0.20
in)
from the edge.
Caution
Securely bond the dam and let it dry.
4. Apply primer with a brush to the circumferences
of the glass and the body, and allow it to naturally
dry for 20 to 30 minutes.
Caution
Be sure not to allow dirt, water, oil etc. to
come in contact with the coated surfaces and
do not touch it with your hand.
5. Install the spacers at the positions shown in the
figure.
Caution
Clips with flaws must be replaced.