7A
ASSEMBLY
2. Assemble
the control
end, ball, spring,
and crank
lever to the clutch housing
as shown in the figure.
Caution
Be careful
not to lose the ball and spring.
3. Install the differential
assembly,
4. Unite the primary
shaft gear, secondary
shaft gear
and shift fork assembly.
Install the control
rod into
the control
end as the unit is lowered
into place.
Note
Keep the assembly
nearly vertical
while in-
stalling it.
5. Align the holes in the control
rod and the control
end.
6. Tap the spring pin in with a pin punch and hammer.
7A-46