Mazda 323 1988 Workshop Manual page 859

MOLDING
14
Snap-in and
st
BELTLINE MOLDING (5 DOOR HATCHBACK)
Removal and Installation
1. Pry up the clip at the end of the beltline molding.
2. Remove the sail outer garnish.
3. Remove the beltline molding mounting screw and
mounting rivet.
4. Lift the molding up to remove it.
5. Install in the reverse order of removal.
TRUNK LID MOLDING
Removal and Installation
I. Remove the trunk lid molding mounting screws.
2. Install in the reverse order of removal.
SIDE PROTECTOR MOLDING (SNAP-IN AND
STICK-ON TYPE)
Note
As shown in the figure, the method of instal-
lation varies according to the installation lo-
cation.
Removal and Installation
1. Remove the rivets and cut the molding free from
the body.
Note
a) Wide molding is a snap-on type. Do not cut
the pins off when removing the glue.
b) Do not damage the painted surface.
2. Install in the reverse order of removal
14-37