Mazda 323 1988 Workshop Manual page 493

ASSEMBLY
7A
0.1 mm (0.0039 in) 0.9 mm (0.0354 in)
0.2 mm (0.0079 in)
1.0 mm (0.0394 in)
0.3 mm (0.0116 in) 1.1 mm (0.0433 in)
0.4 mm (0.0157 in)
1.2 mm (0.0472 in)
0.5 mm (0.0197 inj 0.12 mm (0.0047 inj
0.6 mm (0.0236 in)
0.14 mm (0.0055 in)
0.7 mm (0.0276 in)
0.16 mm (0.0063 in)
0.8 mm (0.0315
inj 1
Example:
(B) = 0.94 mm (0.037 in)
0.94 mm (0.037 in) - 0.70 mm (0.0276 in)
= 0.24
mm (0.0094 in)
So the nearest shim (on the thick side) to 0.24
mm (0.0094 in) is 0.25 mm (0.0096 in).
Note
The number of shims used must not be more
than two.
15. Install the
SST.
16. Adjust the selector with the
SST
until the preload
specification is obtained.
Preload: 0.5 N.m (5 cm-kg, 4.3 in-lb)
17. Measure the clearance between (A) and (B) with
a feeler gauge.
16. Add
0.15 mm
(0.0059
in)
to the measured clear-
ance and select the combination of shims closest
in value to that measurement.
See the table below for available shim sizes.
Note
a) Measure the gap around the entire circum-
ference of the selector
b)The number of shims used must not be
more than three.,
19. Remove the
SST,
and remove the transaxle case.
Remove the shaft gears, selectors, and the
differential.
20. Remove the bearing outer races for both shafts
from the transaxle case.
Leave the differential side bearing outer race in the
clutch housing.
7A-69