Mazda 323 1988 Workshop Manual page 464

7A
ASSEMBLY
Part No.
99963 5110
99963 5115
99963 512"
99963 5125
99963 5130
99963 5135
Thickness
0.10 mm (0.004 in)
0.15 mm (0.006 in)
mm mm (0.008 in)
_.-_
I
0.25 mm (0.010
in)
"3" mm
_.__ (0.012 in)
I 0 35 Inn- ," "44 i")
n)
---I n)
_ _ _ I_, _
99963 5130 0.40 mm (0.016 i
99963 5145
0.45 mm (0.018 i,
99963 5150 0.50 mm (0.020 in)
99963 5155
0.55 mm (0.022 in)
99963 5160
0.60 mm (0.024 in)
99963 5165 0.65 mm (0.026 in)
99963 5170 0.70 mm (0.028 in)
99963 517.5
0.75 mm (0.030 in)
99963 5180
0.80 mm (0.032 in)
99963 5185
99963 51Qi
0.85 mm (0.034 in)
n Qn mm (0.036 in)
t
12. Adjust the selector with the
SST
until the preload
specification is obtained.
Preload:
OS-o.75
N.m (5-7.6 cm-kg, 4.3-6.6
in-lb)
13. Use a thickness gauge to measure the gap in the
selector for the differential.
Caution
Measure the gap around the entire circumfer-
ence of the selector
14. Select an appropriate adjustment shim to be used
for the differential. It should be selected by refer-
ring to the table and selecting the shim which is
nearest (on the large side) to the largest measured
value of the gap in the selector.
Example: 0.54 mm (0.021 In)
So the nearest shim (on the large side) to 0.54
mm (0.021 in) is 0.55 mm (0.022 in).
Caution
The number of shims to be used must not be
more than three.
7A-40