DRIVESHAFT
9
Clip
1. Make matching
marks on the drive shaft and out-
er ring.
Note
Mark with paint, do not use a punch.
2. Remove
the clip with a flat-tipped
screwdriver.
Snap Ring
1. Use a punch
and make
matching
marks
on the
driveshaft
end and inner ring.
2. Remove
the snap ring with snap ring pliers.
Bails, Inner ring, and Cage
Disassemble
in the following
order:
1, Insert a flat-tipped
screwdriver
between
the inner
ring and the cage to remove
the balls.
2. Make matching
marks on the inner ring and cage.
Note
Mark with paint, do not use a punch.
3. Turn the cage approximately
30 degrees,
and then
pull it away from the inner ring.
9-15