Installation - Mazda 323 1988 Workshop Manual

6
CLUTCH AND FLYWHEEL
INSTALLATION
Install in the reverse order of removal and note the
6-20
following:
1. Install the pilot bearing in the flywheel with a suita-
ble rod and a hammer.
2. After installing the flywheel, attach the
SST
and
tighten the flywheel installation bolts.
Tightening torque
96-103 N.m (9.9-10.5 m-kg, 71-75 ft-lb)
Note
If reinstalling flywheel bolts clean threads to
remove old sealant, apply new sealant and
tighten to specification.
If old sealant can not be removed replace
bolts.
3. install the release lever and apply a coating seal-
ant the bolt.
Tightening torque
7.8-10.8 N*m (0.8-1.1 m-kg, 5.8-8.0
ft-lb)
4. Apply clutch grease (Mori White TA No. 2 or
equivalent organic molybdenum grease) to the
shaded areas of the release bearing.