Mazda 323 1988 Workshop Manual page 496

7A
ASSEMBLY
6. Tap in the oil seal using the
SST.
7. Install the previously selected adjustment shims
and the diaphragm springs in the direction shown
in the figure, and install the bearing outer races,
Shift Fork and Shift Rod
.J
Control end
1. Install the control lever onto the control rod, align
each of the spring pin coupling holes, and tap in
new spring pins.
2. Install the shift fork (1 st and 2nd gears) and the con-
trol end onto the control rod so that they face in
the direction shown in the figure, align the control
end and
the spring pin hole in the rod, and
tap in
the new spring pin.
Shift fork (l& and 2nd gears)
76"07.4-114
3. Assemble the shift fork (1st and 2nd gears), the
interlock sleeve and the shift fork (3rd and 4th
gears).
Note
The dot on the interlock sleeve must face to-
ward the 3rd gear and the shift fork.
Shift fork (3rd and
7A-72
323
Revised 10187