Mazda 323 1988 Workshop Manual page 554

ASSEMBLY /c;
r
7. Insert the pinion shaft.
Center Differential
1, Install the differential gear case sleeve.
2. Install the gear case needle bearings and spacer.
3. Install the planetary carrier assembly, gear case
needle bearing, sun gear, gear case needle bear-
ing and the SST.
Note
Apply transaxle oil to the needle bearings.
Measuring plate thickness: 4.3 mm (0.169 in)
4. Measure the clearance between the SST and gear
case needle bearing.
If the clearance is not within specification, select
the proper washer.
Standard: 0.1-0.3 mm (0.004-0.012 in)
Available washer thickness:
3.5 mm (0.138 in) 3.7 mm (0.146 in)
3.9 mm (0.154 in) 4.1 mm (0.161 in)
4.3 mm (0.169 in)
323 Revised 10187 7c-47