Mazda 323 1988 Workshop Manual page 461

ASSEMBLY
7A
1
1. Install the primary and secondary shaft bearing out-
er races into the transaxle case (shims removed).
2. After mounting the clutch housing onto the trans-
axle hanger, install the differential bearing outer
race into the clutch housing.
Next, position a piece of pipe against the outer race
and tap in with a hammer until it contacts the clutch
housing.
3. As shown in the figure, put the outer races into the
SST for primary (49 F401 383) for secondary (49
F401 382A).
Caution
Turn the SST to eliminate the gap indicated
by the arrow in the figure.
4. Set the differential assembly into the clutch hous-
ing, and then mount the assembled SST and bear-
ing outer race on the differential.
Mount the assembled selectors and bearing out-
er races for the primary and secondary shaft into
the clutch housing.
Mount both shaft gear assemblies as shown in the
figure.
5. Mount the transaxle case to the shafts and the
differential selector, as shown in the figure.
323 Revised lo/87
7.4-37