Mazda 323 1988 Workshop Manual page 145

16
ASSEMBLY
Oil pump
7ear cover
Oil Pan
I. Apply sealant to the places indicated by the arrows
in the figure after cleaning the cylinder block
surface.
2. Install the gaskets onto the oil pump body and rear
cover with the projections in the notches as shown.
3. Clean the oil pan contact surface.
Caution
Do not leave any dirt or oil on it.
4. Apply silicone sealant to the oil pan continuously
with the bead of 2.5-3.5
mm (0.0984-0.1378
in),
rimming the surface inside the bolt holes as
shown.
Caution
After the sealant is applied, the pan must be
secured within 30 minutes.
5. Install the oil pan.
Caution
Oil pan projection and recession from the end
of the cylinder block must not be more than
1.5 mm (0.08 in)
6. Tighten the bolts gradually in three steps.
Tightening torque:
8-11 N.m (0.8-1.1 m-kg, 89-95 in-lb)