Mazda 323 1988 Workshop Manual page 868

,I4
SLIDING SUNROOF
C-C cross section
(Cross-section C-C adjustment)
(1) Loosen the installation screw and the adjust-
ing screw.
The adjustment will be easier if the installation
screw is not loosened too much.
(2) Adjust by moving the outer panel from the in-
side or outside.
Installation screw
(3) Tighten the adjusting screw first, and then the
installation screw.
- Caution
If the outer panel operation seems "heavy",
make the following adjustments.
83"14X-027
r-1 11. Instal! the synrqof trim.
12. After rnstallatlon IS completed, check the operation
I
Set plate
and following points:
(1) Is there any foreign material on the sliding parts
of the sunroof?
B
(2) When the sliding panel is opened, does the roof
panel interfere with the rear part? If so, open
the outer panel fully and move the stopper
forward.
Caution
5mm (0.20 in)
If the stopper is moved too far forward, there
might be a malfunction or leaking.
Do
not
leave a gap of more than 5 mm (0.2 in) be-
tween the outer panel and roof panel.
B-B
A-A cross section
cross s+ion
14-46