Mazda 323 1988 Workshop Manual page 110

REMOVAL AND INSTALLATION 1
B
1. Front wheels
12. Connectors (thermometer,
20. Driveshafts
2. Battery
electric fan switch) 21. Exhaust pipe
3. Air cleaner 13. Radiator
22. Propeller shaft (for 4WD)
4. Battery carrier 14. Canister hoses 23. Engine mount member
5. Clutch release cylinder 15. Vacuum hoses 24. Control unit
6. Ground (body-transmission) 16. Accelerator cable 25. No. 3 engine mount
7. Back lamp connector
up
17. intercooler 26. No. 2 engine mount
8. Engine harness connectors 18. Under cover and side
27. No.. 4 engine mount
9. Shift control cables cover
(for 4WD)
IO. Heater hoses
19. Connectors (starter motor,
11. Speedometer cable
oil pressure switch, al-
ternator)
lntercooler
1, Disconnect the air hose from intercooler.
Caution
Cover the end of air pipes and hoses with rag
to prevent any foreign material from falling
into the turbocharger or intake system.
Note
Do not insert screw driver or other between
air hose and intercooler pipe, when discon-
necting
2. Remove the intercooler
Note
Be careful not to damage to the fins.
Fuel Hose
After disconnecting the fuel hoses (inlet and return),
plug them to avoid fuel leakage.
Warning
Keep sparks and open flame away from the
fuel area.
Caution
When disconnect the hoses, cover the hoses
with a rag since fuel will splash out.
16-23