Mazda 323 1988 Workshop Manual page 832

14
REAR COMBINATION LIGHT
REPLACEMENT OF COMBINATION LIGHT LENS
1. Use a blow dryer to soften the "hot melt" (bond-
ing agent) around the lens to be replaced.
2. Remove the lens from the light housing by push-
ing the rear of the lens with a hammer handle or
round bar.
3. While heating the light housing, remove the "hot
melt" and any remaining fragments of the lens.
Note
The "hot melt" should be reused if possible.
4. If the hot melt is not being reused, put Uni-sealer
(8531 77 739) in the light housing groove for adhe-
sive, and press the light housing in gently.