Mazda 323 1988 Workshop Manual page 490

7A
ASSEMBLY
-
-
1. Install the primary and secondary bearing outer
races into the transaxle case (shims removed).
2. Mount the clutch housing on the transaxle hang-
er, and install the differential bearing outer race with
brass drift until it is flush with the clutch housing.
3. Position a piece of pipe [outer diameter 68 mm
(2.68 in) or less] against the differential bearing out-
er race and tap with a hammer until it contacts the
clutch housing.
Outer race
Differential
Outer races -===z=
Secondary shaft /
aseem bly
.Transaxle case
- Outer rases
-Primary shaft assembly
- Outer rase
-Clutch housing
4. Install the outer races into the SST.
5. Mount the differential assembly to the clutch hous-
ing, and mount the assembled selector and bear-
ing outer race on the differential.
6. Mount the assembled selector and bearing outer
race for primary and for secondary shaft into the
clutch housing.
7. Mount both shaft gear assemblies as shown.
7A-66