Mazda 323 1988 Workshop Manual page 471

ASSEMBLY
7A
Gate
Raise the reverse lever and install the gate in its
groove and guide pin.
Shift Rod (5th and reverse)
When installing the shift rod (5th and reverse), make
sure that the alignment mark on the rod is in the cor-
rect position.
Interlock Sleeve and Reverse Idle Shaft
Before installing the transaxle case, make sure the
control lever (arrow) is kept flush with the surface of
the end of the interlock sleeve. Point the threaded hole
of the reverse idle shaft toward the alignment mark
of the clutch housing.
Sealant
Coat sealant sparingly onto the matching surfaces of
the case and housing, and the case and rear cover.
7A-47