Mazda 323 1988 Workshop Manual page 146

ASSEMBLY 1
B
Flywheel (MIX)
1. Tap the pilot bearing in with a suitable pipe and
hammer.
2. Apply sealant to the flywheel bolts.
Caution
If reinstalling flywheel bolts, clean threads to
remove old sealant, apply new sealant and
tighten to specification.
If old sealant can not be removed, replace
bolts.
3. install the flywheel, with the SST white tightening.
Tightening torque:
96-103 Nqm (9.8-10.5 m-kg, 71-76 ft-lb)
Clutch Disc and Clutch Cover
Install the clutch disc and clutch cover with the SST,
and tighten the clutch cover.
Tightening torque:
18-26 N.m (1.8-2.7 m-kg, 13-20 ft-lb)
Note
Follow the clutch disc installation directions
exactly (See Section 6).
Valve Seal
1. Apply engine oil to the inner surface of the new
valve seal.
2. Install the valve seal onto the valve guide with the
SST.
Valve and Valve Spring
1. Install the lower spring seat.
2. Install the valve.
3. Install the valve spring and the upper spring seat.
Note
Install the spring with its narrow pitch end to-
ward the cylinder head.
1 B-59