Mazda 323 1988 Workshop Manual page 447

DliASSEMBLY
7A
Shift Fork Assembly
Disassemble the 1 st - 2nd shift fork, interlock sleeve
and 3rd - 4th shift fork after setting them as shown
in the figure. Slide the 3rd 4th shift fork and inter-
lock sleeve off the shaft
Bearing Inner Race (1st gear end of primary shaft
gear)
Press the bearing inner race from the shaft with the
SST.
Caution
Hold the shaft with one hand so that it does
not fall.
Bearing Inner Race (4th gear end of primary
shaft aeart
Press &e dearing inner race from the shaft with the
SST.
Caution
Hold the shaft with one hand so that it does
not fall.
Bearing inner Race and 4th Gear (secondary
shaft oear assemblv1
Remove the bearing ir%er
the SST.
race and the 4th gear with
Piston the puller between the two sets of gear teeth
on the 4th gear.
Caution
Hold the shaft with one hand so that it does
not fall.
7A-23