Mazda 323 1988 Workshop Manual page 623

DRIVESHAFT 9
5. Align the matching marks, then install the cage and
inner ring on the shaft.
6. Install the snap ring.
7. Carefully fit the boot to the grooves in the shaft and
outer ring.
Boot Band
Tighten the boot band according to the following
procedure:
Note
a) Always use a new band.
b)The band should be folded in the direction
opposite to the forward revolving direction
of the driveshaft.
1. Fold the band back by pulling on the end of the
band with pliers.
2. Lock the end of the band by bending the locking
clio.
9-17