Mazda 323 1988 Workshop Manual page 532

DISASSEMBLY
7ti
DISASSEMBLY-STEP 3
Disassemble in the sequence shown in the figure.
Note
a) Do not disassemble the bearing inner races (except the secondary 4th gear end @ of
the secondary shaft gear assembly and the 4th gear end @ of the primary shaft gear
assembly) unless necessary. Replace them with new races whenever they are disas-
sembled.
b)Before disassembly, check the thrust clearance of all gears. (Refer to page 7C-62)
63G07C-30
1. Bearing inner race
8. Primary shaft gear
2. 4th gear
9. Bearing inner race
3. Synchronizer ring 10. Bearing inner race
4. Retaining ring
11. Secondary 4th gear
5. Clutch hub assembly 12. Retaining ring
6. Synchronizer ring 13. Secondary 3rd gear
7. 3rd gear
14.2nd gear
15. Synchronizer ring
16. Retaining ring
17. Clutch hub assembly
18. Synchronizer ring
19.Ist gear
20. Secondary shaft gear
21, Searing inner race
22. Reverse gear
7C-25