Mazda 323 1988 Workshop Manual page 480

7A
DISASSEMBLY
,rn,w,nn , vr,mr I,
Bearing Inner Race (4th gear side)
Press the bearing inner race from the shaft using the
SST.
Caution
,m fa,,.
Hold the shaft with one hand so that it doesn't
Clutch Hub Assembly (3rd and 4th gears)
Set the
SST
onto the 3rd gear, and press off the
clutch hub assembly together with the gear.
Caution
Hold the shaft with one hand so that it doesn't
fall.
DIFFERENTIAL
Disassemble in the sequence shown in the figure.
Note
Replace the bearing inner race with s new one.
1. Side gears
2. Thrust washers
3. Spring pin
4. Pinion shaft
5. Thrust washers
6. Pinion gears
7. Side bearings
8. Speedometer
drive gear
9. Ring gear and
gear case as-
sem bly
7A--56