Mazda 323 1988 Workshop Manual page 634

9
FRONT AXLE
i
T
1
Grease
Completely fill the shaded area in the figure with lithi-
um grease
(NLGI
No. 2 or equivalent).
I
Oil Seal
Install the outer oil seal with a plastic hammer.
Note
a) Use a new oil seal and apply grease to the
lip of the seal.
b) Make sure the oil seal is installed flush with
the knuckle.
Install the inner oil seal with SST and a hammer.
Note
a) Use a new oil seal and apply grease to the
lip of the seal.
b)Make sure the oil seal is installed flush with
the knuckle.
Wheel Hub
When press-fitting the wheel hub into the knuckle (with
the bearing and oil seal), use
SST
and press-fit with
a press.
Press to 24,500 N (2,500 kg, 5,500 lb)