9
REAR DIFFERENTIAL
Adjustment
of Pinion Height
1, Install the front and rear bearing
outer races us-
ing a brass drift and a hammer.
2. Adjust drive pinion height as follows using the
SST
3. Fit the spacer,
rear bearing,
and
SST.
Secure the
3. Fit the spacer,
rear bearing,
and
SST.
Secure the
collar with the "0"
ring. Then
install this to the
collar with the "0"
ring. Then
install this to the
carrier.
carrier.
4. Attach the front bearing,
SST,
companion
flange,
4. Attach the front bearing,
SST,
companion
flange,
washer,
and nut to the drive
pinion
model.
washer,
and nut to the drive
pinion
model.
Note
a) Use the same spacer and nut which were
removed
at disassembly.
b) Be sure to install collars A and B in the cor-
rect position
and facing
in the correct
direction.
5. Tighten
the nut to the extent that the drive pinion
model
can be turned
by hand.
9-56