Mazda 323 1988 Workshop Manual page 477

DISASSEMBLY
7A
Bearing Outer Race (on engine side of primary
shaft)
Mount the
SST,
then reverse the clutch housing and
use a piece of pipe to tap out the bearing outer race
through the primary shaft hole.
Caution
Before the bearing outer race comes all the
way out, tap with lighter strokes and hold it
to prevent it from failing.
Bearing Outer Race (between secondary shaft
and engine)
Remove the bearing outer race by lifting out the fun-
nel and the race together.
Spring Pin
Align the groove for removal of the clutch housing
pin with the position of the spring pin, then tap the
pin out using a pin punch.
Bearing Outer Race (differential side)
Mount the
SST,
then use a piece of pipe to tap out
the bearing outer race through the driveshaft hole.
Caution
Before the bearing outer race comes all the
way out, tap with lighter strokes and hold it
to prevent it from falling.
7A-53