Advertisement
Method 2
1
2
Method 3
1
Method 4
2
1
2
Connecting the power cord for a DC power module
1
2
3
2
3
Installing an interface module
This section is applicable only to switch models that support expansion cards.
To avoid damage, do not touch the electronic components on an expansion card.
Various types of expansion cards Are available for the switch. The installation method varies by
expansion card type. Select an installation method as required.
Make sure each slot has a module or filler panel installed when the switch is operating.
Remove a filler panel
1
2
Install an expansion card (method 2)
2
1
An LSPM6FWD interface module installed on the device adds 75 mm (2.95 in) to the
chassis depth.
The information in this document is subject to change without notice.
Install an expansion card (method 1)
2
1
4
3
Copyright © 2019, New H3C Technologies Co., Ltd.
Advertisement
