Configuring Source Ip Address Of Igmp Queries - H3C S3610 Series Operation Manual

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
II. Configuring IGMP timers in a VLAN
Follow these steps to configure IGMP timers in a VLAN:
Enter system view
Enter VLAN view
Configure IGMP general
query interval
Configure the maximum
response time to IGMP
general queries
Configure
last-member
interval
Caution:
In the configuration, make sure that the IGMP general query interval is larger than the
maximum response time for IGMP general queries.

2.5.4 Configuring Source IP Address of IGMP Queries

Upon receiving an IGMP query whose source IP address is 0.0.0.0 on a port, the switch
will not set that port as a router port. Therefore, we recommend that you configure a
valid IP address as the source IP address of IGMP queries.
Follow these steps to configure source IP address of IGMP queries:
Enter system view
Enter VLAN view
Configure
address of IGMP general
queries
Configure the source IP
address
group-specific queries
To do...
system-view
vlan vlan-id
igmp-snooping
query-interval interval
igmp-snooping
max-response-time
interval
the IGMP igmp-snooping
query last-member-query-inte
rval interval
To do...
system-view
vlan vlan-id
igmp-snooping
the source
general-query source-ip
{
ip-address }
igmp-snooping
special-query source-ip
of IGMP
{
ip-address }
Chapter 2 IGMP Snooping Configuration
Use the command...
Use the command...
current-interface
current-interface
2-15
Remarks
—
—
Optional
60 second by default
Optional
10 seconds by default
Optional
1 second by default
Remarks
—
—
Optional
|
0.0.0.0 by default
Optional
|
0.0.0.0 by default