T S - 4 0 0 U S E R G U I D E
CONFIGURING YOUR TS-400
To configure your TS-400, press
Configuring 7- an d 10-digit Dialling
For use outside of North America, do not program any area codes. When calling from
the Caller ID (CLID) list, numbers will be dialled exactly as received from the network.
Configure outside line access
The display indicates the OUTSIDE ACCESS? prompt.
Enter the outside line access code (up to 4 digits), or press
#
if your extension is configured for direct line access.
DIAL/ENTER
Press the
If you enter an outside line access code by mistake, press the
DELETE
button or the
Configure Paging
1
Press
to configure for External Paging or press
configure for Group Paging to telephone sets. If you select Group
Paging, you must also enter a ring group number (300–309).
ADJUSTING THE DISPLAY ANGLE
You can optimize the LCD display by adjusting the viewing angle. To adjust the LCD
viewing angle, move the rear edge of the LCD module up or down.
ADJUSTING THE DISPLAY CONTRAST
The display can be adjusted to suit the light level of your room and your viewing
preference. To make the contrast of the display lighter or darker, press the
to the right of the screen until the desired contrast is reached.
ADJUSTING THE HANDSET RECEIVER VOLUME
If you need to adjust the handset receiver volume:
1. Lift the handset and listen to the dial tone.
2. Press the right side of the
3. Press the left side of the
4. Replace the handset when the desired receiver volume is reached.
6
MENU
.
button.
button to delete the digits.
VO LUME
button to increase the receiver volume.
VO LUME
button to decrease the receiver volume.
2
to
H T T P : / / G LO B A L .T A L K S W I T C H . CO M
_ _ _ _
OUTSIDE ACCESS?
9 _ _ _
OUTSIDE ACCESS?
_
>1=PA
2=GROUP
button