Xerox ColorQube 9303 Series Service Manual page 1116

Take care when releasing or tensioning the drive belt not to trap or damage the adjacent wiring
harness.
Ensure that the inside surface of the drive belt does not become contaminated with oil, ink or
paper debris during removal or installation. Clean the drive belt as necessary, refer to
3. Remove the drum drive belt, Figure
3
Remove the belt from
the drum drive motor.
Figure 2 Drum drive belt removal
Repairs/Adjustments
REP 91.24
CAUTION
CAUTION
2.
1
Release the tension on
the belt by pulling the
lever down and rotating
the drum drive motor.
2
Remove the belt from
the drum pulley.
4. Remove the drum drive motor,
GP 27.
2
Disconnect the top
harness from the
drum drive motor.
Replacement
1. Replacement is the reverse of the removal procedure.
2. Before installing the drum drive belt, clean the drum pulley,
27.
February 2013
4-358
Figure 3.
3
Unhook the spring from
the lever.
5
Rotate the drum drive motor in
an anti clockwise direction then
1
remove it from the shaft.
Disconnect the harness
from the PSU.
Figure 3 Drum drive motor removal
PL 94.20 Item
ColorQube® 9303 Family
4
Remove the e-clip.
3. Refer to GP