Rep 75.9 Tray 5 Docking Latch - Xerox ColorQube 9303 Series Service Manual

2. Remove the front or rear cover, Figure
1
Remove two screws
1
Remove two screws at
the front and two at the
rear
Figure 2 Front and rear cover
Replacement
1. The replacement is the reverse of the removal procedure.
2. Check that the top cover is located correctly,
Repairs/Adjustments
REP 75.8, REP 75.9
2.
2
Loosen two screws and
remove the rear cover.
2
Remove the front
cover
Figure 1.

REP 75.9 Tray 5 Docking Latch

Parts List on PL 75.62
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present can cause injury.
1. Remove the paper and un-dock the tray 5 module,
2. Remove the two screws and unhook the spring,
3
Remove screw
February 2013
4-280
WARNING
GP 14. Disconnect the power cord
WARNING
REP 75.7.
Figure 1.
1
2
Remove screw
Unhook the spring
Figure 1 Preparation
ColorQube® 9303 Family