Rep 82.1 3 Tray Module Transport Motor; Rep 82.2 3 Tray Module Transport Drive Belt - Xerox ColorQube 9303 Series Service Manual

REP 82.1 3 Tray Module Transport Motor

Parts List on PL 73.16
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the rear cover, PL 70.25 Item
2. Remove the 3 tray transport motor,
NOTE: It is important to mark the position of the motor before the motor is removed.
5
Remove 4 screws.
2
Mark the position of the motor.
1
Disconnect harness.
Figure 1 3 tray module transport motor
Replacement
1. Relocate the 3 tray module transport drive belt.
2. Replacement is the reverse of the removal procedure. Ensure that the motor is aligned
with the mark.
3. After completing the replacement procedure, perform the
calibration.
Repairs/Adjustments
REP 82.1, REP 82.2
WARNING
GP 14. Disconnect the power cord
WARNING
8.
Figure 1.
4
Remove screw and
ground wire.
3
Loosen the belt tension
screw.
dC625 Registration / Preheat

REP 82.2 3 Tray Module Transport Drive Belt

Parts List on PL 73.16
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the rear cover, PL 70.25 Item
2. Remove the 3 tray module transport motor,
3. Remove the transport drive belt,
1
Remove the transport
drive belt.
Replacement
1. Reverse the removal procedure to replace the transport drive belt.
2. After completing the replacement procedure, perform the
calibration.
February 2013
4-300
WARNING
GP 14. Disconnect the power cord
WARNING
8.
REP 82.1.
Figure 1.
Figure 1 Transport drive belt
dC625
ColorQube® 9303 Family
Registration / Preheat