REP 8.1 Side Cover Assembly
Parts List on
PL 7.30
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1.
Remove the rear cover,
PL 28.10 Item
2.
Open the side cover assembly,
PL 7.30 Item
3.
Remove the Bypass Feed Clutch and the cable clamp
2
Disconnect the ground
harness by removing the
screw.
Figure 1 Removing the Bypass Feed Clutch and Cable Clamp
WorkCentre 4150/4250/4260WorkCentre WorkCentre 4150/4250/42604150/
WARNING
WARNING
CAUTION
GP
6.
1.
(Figure
1).
3
Remove the cable
clamp.
1
Remove the KL-clip, then the
bypass feed clutch.
4.
Prepare to remove the Side Cover Assembly
3
Route the wire harness out
the side of the machine.
10.
Side Cover Assembly
wire harness
Figure 2 Preparing to Remove the Side Cover Assembly
January 2016
4-127
(Figure
2).
2
Disconnect the wire harness con-
nector from the Main PWB.
1
Route the wire harness out
of the four cable clips.
Repairs and Adjustments
REP 8.1