Rep 75.6 Tray 5 Down Limit Switch - Xerox ColorQube 9303 Series Service Manual

4. Remove the tray 5 upper limit switch and the actuator if required,
Figure 2 Remove tray upper limit switch
Replacement
1. The replacement is the reverse of the removal procedure.
Repairs/Adjustments
REP 75.5, REP 75.6
Figure 2.

REP 75.6 Tray 5 Down Limit Switch

Parts List on
Removal
3
Remove screw and Switch off the electricity to the machine. Refer to
release the spring to
from the customer supply while performing tasks that do not need electricity. Electricity
remove the actuator
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present can cause injury.
2
1. If the tray must be repositioned, refer to
Remove two
tray and move the tray to the required position. Re-engage the elevator motor to hold the
screws and
tray.
remove switch
2. Release the paper tray to gain access to the tray 5 down limit switch,
1
Disconnect harness
Tray 5 down limit switch
February 2013
4-276
PL 75.70
WARNING
GP
WARNING
REP 75.4. Disengage the elevator motor from the
1
Remove three screws
Figure 1 Release the paper tray
14. Disconnect the power cord
Figure 1.
ColorQube® 9303 Family