Xerox ColorQube 9303 Series Service Manual page 1050

3. Remove tray 1 or tray 2 feed rolls,
NOTE: The removal procedure is the same for tray 1 or tray 2. The feed and nudger rolls
are the same diameter but the retard roll has a larger diameter.
3
Lift the tab and remove
the feed roll
Figure 2 Remove the feed rolls
Repairs/Adjustments
REP 81.4
Figure 2.
1
Lift the tab and remove
2
the nudger roll
Lift the tab and remove
the retard roll
Replacement
1. The replacement is the reverse of the removal procedure.
2. Make sure that the tabs on the feed roll are located in the drive shaft.
3. Ensure that the guide is located correctly on the feeder assembly,
4. Check the registration, refer to
5. When new feed rolls are installed, reset the tray 1 or tray 2 feed count to zero. Refer to
dC135 CRU / HFSI Status.
February 2013
4-292
Figure
Ensure that the location lugs
on the guide are positioned
correctly
Figure 3 Locate the guide
dC625 Registration / Preheat calibration.
ColorQube® 9303 Family
3.