Rep 81.7 Tray 5 Feed Rollers - Xerox ColorQube 9303 Series Service Manual

REP 81.7 Tray 5 Feed Rollers

Parts List on PL 81.45, PL 81.46
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Open the tray 5 door and allow the tray to move down.
2. Remove the nudger and the feed roller from the front. Slide the tray 5 module away from
the machine and remove the retard roller,
Repairs/Adjustments
REP 81.7
WARNING
GP 14. Disconnect the power cord
WARNING
Figure 1.
2
Lift the tab and slide
1
the nudger and feed
Lift the guide.
roll off the drive shaft
Replacement
1. The replacement is the reverse of the removal procedure.
2. Ensure that the tabs on the feed roll are located in the drive shaft.
3. Check the registration, refer to
4. If a new nudger / feed and retard roll are installed, reset the tray 5 feeds count to zero.
Refer to dC135 CRU / HFSI Status.
February 2013
4-294
1
Lift the tab and slide the retard roll
off the drive shaft
Figure 1 Remove the feed rolls
dC625 Registration / Preheat calibration.
ColorQube® 9303 Family