Rep 89.1 Registration / Preheat Assembly And Lower Platelet Assembly - Xerox ColorQube 9303 Series Service Manual

3. Remove the duplex drive belts and takeaway rolls,
Figure 2 Drive belts and takeaway rolls removal
Replacement
Replacement is the reverse of the removal procedure.
Repairs/Adjustments
REP 83.5, REP 89.1
Figure 2.
1
Remove the E-clips and
slide off the pulleys and belt
2
Slide takeaway roll to front
of paper path to remove it
1
Remove the E-clips and
slide off the pulleys and belt
February 2013
4-314
REP 89.1 Registration / Preheat Assembly and Lower
Platelet Assembly
Parts List on PL 88.10
Procedure
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Go to the relevant procedure:
• Registration / Preheat Assembly Removal
• Lower Platelet Assembly Removal
Registration / Preheat Assembly Removal
Do not touch the printheads.
Protect the surface of the drum with paper.
1. Open the front door. Remove the inner cover,
2. Remove the horizontal transport, REP
WARNING
GP 14. Disconnect the power cord
WARNING
CAUTION
CAUTION
PL 81.11 Item 2.
83.1.
ColorQube® 9303 Family