Table of Contents
Advertisement
2
Remove the screw, then remove
the front elevator tray guide
Figure 4 Elevator tray guides removal
Replacement
1.
Re-assemble the elevator tray by reversing the removal steps 3 to 5.
2.
Install the rear guide assembly,
Figure 5
1
Compress the spring into the cavity and
retain the spring using a thumb or finger
Figure 5 Rear guide assembly install
Repairs/Adjustments
REP 75.11
1
Remove the screw, then
remove the rear elevator
tray guide
and
Figure
6.
3
Position the fix-
ing plate over
the actuator
arm and place
the tongue in
the cutout
2
Position the infill plate
in the tray assembly
1
Position the spring stop between the spring and the inside end of the cavity
Figure 6 Rear guide assembly install
3.
The remainder of the installation is the reverse of the removal procedure, refer to
75.10
and perform the replacement procedure.
February 2013
4-286
3
Insert and tighten
2 screws
2
Locate the
retaining plate
dowels in the
locating holes
REP
ColorQube® 9303 Family
Advertisement
Chapters
Table of Contents
