Xerox ColorQube 9303 Series Service Manual page 1172

Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
1. Perform the adjustments that follow as necessary to meet with the customer C fold and Z
fold requirements, Figure 2.
C Fold profile
Figure 2 C folded and Z folded output copy profiles
NOTE: Figure 2. Shows the orientation of a C and Z folded copy on the tri-folder output tray, as
viewed from the front of the machine.
A Folds
Figure 2. The folds marked A are created within the booklet maker module. The length of the A
fold is determined by the NVM values in dC131. An increase to the NVM value by 30 will
decrease the A fold by 1 mm. A decrease to the NVM value by 30 will increase the A fold by 1
mm.
• Use dC131 code 12-009 to make adjustments to C folded copies.
• Use dC131 code 12-010 to make adjustments to Z folded copies.
B Folds
Figure 2. The folds marked B are created within the tri-folder module. The length of the B fold is
determined by the position of the paper setting adjusters. If necessary remove the front door,
PL 12.200 Item 2, front cover PL 12.200 Item 12
reposition the paper setting adjusters. Figure
size adjuster scale will adjust the position of fold B by 1 mm.
• Raise the paper setting adjusters to decrease fold B.
Repairs/Adjustments
ADJ 12.12-171
WARNING
Z Fold profile
and the rear cover PL 12.200 Item
3. An adjustment of 1 graduation on the paper
• Lower the paper setting adjusters to increase fold B.
2.
Move the adjuster
3
Fasten the screw.
1
Loosen the screw.
Figure 3 Set the paper size adjusters.
3, then
February 2013
4-414
2
Move the adjuster.
3
Fasten the screw.
1
Loosen the screw.
ColorQube® 9303 Family