Rep 83.2 Duplex End Sensor, Nip C Solenoid And Hpp Diverter Solenoid - Xerox ColorQube 9303 Series Service Manual

REP 83.2 Duplex End Sensor, Nip C Solenoid and HPP
Diverter Solenoid
Parts List on PL 82.15
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Take care during this procedure. Motors will become hot during normal operation.
1. Remove the horizontal paper path,
2. Prepare to remove the duplex end sensor,
NOTE: Hold down the cover against the force of the spring when removing screws.
1
Remove screws marked A.
Figure 1 Preparation
Repairs/Adjustments
REP 83.2
WARNING
GP 14. Disconnect the power cord
WARNING
WARNING
REP 83.1.
Figure 1.
2
Remove the top cover.
3. Remove the duplex end sensor,
Figure 2 Duplex end sensor removal
February 2013
4-310
Figure 2.
1
Move sensor
retainer to the left
2
Disconnect har-
ness and remove
sensor
ColorQube® 9303 Family