Table of Contents
Advertisement
7.
Figure
2, check the alignment of the sheet against the scale.
Top of sheet must align
with the bottom mark
on the B scale.
Figure 2 Top edge alignment
8.
If the sheet is correctly aligned, do the following:
a.
Enter Service Mode
GP
1.
b.
Select Adjustment Routines.
c.
Select
dC131
NVM Read / Write.
d.
Enter NVMID 12-003 BookMkrCompileOff-set.
Repairs/Adjustments
ADJ 12.6-171
e.
Select Read / Write and decrease the value by 80, this will return the NVM value to
the original setting.
f.
Select Save, select OK, select Close, select Exit.
g.
Re-install the BM right hand cover, if removed in step 5.
9.
If the sheet is not correctly aligned, perform the adjustment.
Adjustment
1.
Do the following
a.
Enter Service Routine
b.
Select Adjustment Routines.
c.
Select
dC131
NVM Read / Write.
d.
Enter NVMID 12-003 BookMkrCompileOff-set.
e.
Select Read/Write and enter the new value to correct the error found during the
check. Increasing the value will raise the sheet. Decreasing the value will lower the
sheet. One step = 0.1137 mm.
f.
Select Save, select OK, select Close, select Exit.
2.
Repeat the Check to ensure the compiling position is correctly set.
3.
Do the following:
a.
Enter Service Mode
b.
Select Adjustment Routines.
c.
Select
dC131
NVM Read / Write.
d.
Enter NVMID 12-003 BookMkrCompileOff-set.
e.
Select Read / Write and decrease the value by 80.
f.
Select Save, select OK, select Close, select Exit.
g.
Re-install the BM right hand cover, if removed in step 5.
4.
When the compiling position is correct, switch the machine off then on,
February 2013
4-408
GP
1.
GP
1.
ColorQube® 9303 Family
GP
14.
Advertisement
Chapters
Table of Contents
