Rep 91.20 Ink Reservoir Assembly - Xerox ColorQube 9303 Series Service Manual

3. Remove sensor assembly, Figure 2.
Figure 2 Sensor assembly removal
Replacement
1. Replacement is the reverse of the removal procedure.
2. Refer to the replacement of the ink loader assembly
ColorQube® 9303 Family
1
Remove 2 screws then
the ink low sensor
assembly.
REP 91.15, to reset the ink levels.
February 2013
4-349

REP 91.20 Ink Reservoir Assembly

Parts List on PL 93.10
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Do not touch the exposed face of the printheads. Surface contamination or minor damage can
destroy the printhead.
The drum is exposed when the marking unit is pulled out.
Allow 30 minutes for the umbilicals and reservoir to cool down before starting this repair. It
takes 30 minutes for the ink to solidify.
1. Slide out the marking unit to the maintenance position, refer to
2. Remove the side and umbilical end insulation from the ink reservoir,
Figure 1 Insulation removal
WARNING
GP 14. Disconnect the power cord
WARNING
CAUTION
CAUTION
CAUTION
GP 6.
Figure
1
Remove the umbilical end
insulation.
2
Remove the side insulation.
Repairs/Adjustments
REP 91.19, REP 91.20
1.