Rep 62.1 Scanner Module - Xerox ColorQube 9303 Series Service Manual

REP 62.1 Scanner Module

Parts List on PL 62.10
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Mandatory safety warning. This procedure must be performed by 2 people. The module
is heavy.
1. Remove the DADH, REP 5.19.
ColorQube® 9303 Family
WARNING
GP 14. Disconnect the power cord
WARNING
WARNING
2. Prepare to remove the scanner,
3. Remove the SBC PWB cover,
4. Disconnect PJ15, PJ18, PJ19 and PJ223 from the single board controller PWB.
5. Disconnect PJ8 from the power distribution PWB.
6. Release the harnesses from around the post, refer to
Use safe handling procedures when removing the module. Refer to
is heavy.
NOTE: The weight of the scanner is 15Kg (33lb).
7. Remove the scanner module,
February 2013
4-243
Figure 1.
1
Remove 2 screws, then
the harness guide plate.
2
Cut the cable
tie that secures
the UI harness.
Post
Figure 1 Preparation
PL 3.11 Item 11.
Figure 1.
WARNING
GP
Figure 2.
Repairs/Adjustments
16. The module
REP 62.1