Left Temperature Door Motor V158 , Removing And Installing, "Comfort" Version; Left Temperature Door Motor V158 , Removing And In- Stalling, Comfort Version - Audi Q7 2007 Repair Manual

Removing
– Remove the retaining plate -C- with control motors -V108- and
-V158- . Refer to
⇒ "9.9 Retaining plate with Left Footwell Door Motor V108 and
Left Temperature Door Motor V158 , Removing and Installing",
page 114 .
– Mark the control motors if necessary (versions vary. Refer to
the Parts Catalog).
– Remove the bolts -D- from the Left Footwell Door Motor -
V108- -A- and remove the control motor.
Installing
Remove the control motor on retaining plate.
– Install the retaining plate -C- with control motors -V108- and -
V158- . Refer to
⇒ "9.9 Retaining plate with Left Footwell Door Motor V108 and
Left Temperature Door Motor V158 , Removing and Installing",
page 114 .
Note
Check the lever position of the control motors before installing
retaining plate, the retaining plate can only be installed correctly
when it is located in the service position. Refer to
⇒ "9.9 Retaining plate with Left Footwell Door Motor V108 and
Left Temperature Door Motor V158 , Removing and Installing",
page 114 .
– Install the removed components again in reverse order.
– Check the DTC memory of the Climatronic Control Module -
J255- front A/C control head and erase DTCs displayed if
necessary. Use the Vehicle Diagnostic Tester via the "Guided
Fault Finding" function.
– If necessary, perform a basic setting and output diagnostic test
mode on the A/C system. Use the Vehicle Diagnostic Tester
via the "Guided Fault Finding" function.
9.8 Left Temperature Door Motor - V158- ,
Removing and Installing, "Comfort" Ver‐
sion
Note
Only installed on vehicles with a "Comfort" version A/C system
♦
On vehicles with Climatronic Control Module - J255- front A/C
♦
control head "Basic" version, the left and right temperature
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
doors are operated by the Left Temperature Door Motor -
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
V158- (both left and right doors are connected to each other
with respect to the correctness of information in this document. Copyright by AUDI AG.
via a shaft, motor is installed at right on the A/C unit).
Left Temperature Door Motor - V158- "Basic" version, remov‐
♦
ing and installing. Refer to
⇒ "9.21 Right Temperature Door Motor V159 (or Left Tem‐
perature Door Motor V158 ), Removing and Installing",
page 151 .
The Left Temperature Door Potentiometer/Actuator - V158- is
♦
installed in Left Temperature Door Motor - G220- .
Heating, Ventilation and Air Conditioning - Edition 04.2013
9. A/C System Control Components Inside Passenger Compartment
Audi Q7 2007 ➤
113