Audi Q7 2007 Repair Manual page 299

– Remove the boot -A-.
– Remove driveshaft -B- from splines of drive pinion -C-
Note
Currently, the boot -A- is secured against slipping by a clamp on
flange of drive toothed gear -C- of engine.
Installing
Install in reverse order of removal. Note the following:
– Check driveshaft -B-, splines must show no traces of wear and
must be seated free of play in splines of drive wheel -C-.
– Coat the driveshaft splines -B- with Grease - G 000 100- before
inserting. Refer to the Parts Catalog.
– Insert driveshaft -B- before installing compressor and slide it
into drive wheel -C- up to stop.
– After installing compressor, check installation position of boot
-A-.
The boot -E- is secured against slipping by the clamp on the pow‐
er steering pump flange. Refer to the Parts Catalog.
16.8 Drive Plate with Overload Protection,
Removing and Installing (Vehicles with
8-Cylinder FSI Engine)
– Remove the compressor. Refer to
⇒ "16.4 Compressor, Removing and Installing (Vehicles with
8-Cylinder FSI Engine)", page 283
16. Compressor, Removing and Installing (Vehicles with 8-Cylinder Engine and 12-Cylinder TDI Engine)
Heating, Ventilation and Air Conditioning - Edition 04.2013
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
293