Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
– If necessary, clean upper area of inside surface of receiver/
dryer -B- and coat it lightly with refrigerant oil.
– Replace the cap -A- and the O-rings -C-. Refer to the Parts
Catalog.
– Coat new O-ring seal -C- of the new cap -A- lightly with refrig‐
erant oil before installing. Refer to
⇒ "3.6 Refrigerant Circuit O-Ring Seals", page 26
– Take the new dryer bag -D- out of the transport packing and
install it. Refer to the Parts Catalog.
Note
Do not install any dryer bag that has been exposed to the air
♦
longer than absolutely necessary because it will have absor‐
bed moisture from the air. This includes cartridges that were
not stored in their original packaging or whose packaging is
damaged. Refer to ⇒ A/C System with Refrigerant R134a;
Rep. Gr. 87 ; A/C System General Information (A/C System
with Refrigerant R134a; A/C System General Information).
A dryer cartridge which has been exposed to ambient air is
♦
rapidly saturated with moisture and therefore cannot be used.
– Install the cap -D- and secure it with the circlip -C-.
Dryer Cartridge on a Version "2" Condenser
268
Rep. Gr.87 - Air Conditioning
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.