Audi Q7 2007 Repair Manual page 184

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
13 - Left Rear Air Door Motor - V239-
❑ With Left Rear Air Door Position Sensor - G389-
❑ Removing and Installing. Refer to
⇒ "9.45 Left Rear Air Door Motor V239 , Removing and Installing", page 187
14 - Left Rear Temperature Door Motor - V313-
❑ With Left Rear Temperature Door Position Sensor - G391-
❑ Removing and Installing. Refer to
⇒ "9.46 Left Rear Temperature Door Motor V313 , Removing and Installing", page 188
15 - Right Rear Vent Temperature Sensor - G406-
❑ Installed in rear air duct channel. For removing and installing, refer to
⇒ "9.47 Right Rear Vent Temperature Sensor G406 and Left Rear Vent Temperature Sensor G405 ,
Removing and Installing", page 189
16 - Left Rear Vent Temperature Sensor - G405-
❑ Installed in rear air duct channel. For removing and installing, refer to
⇒ "9.47 Right Rear Vent Temperature Sensor G406 and Left Rear Vent Temperature Sensor G405 ,
Removing and Installing", page 189
17 - Right Rear Heated Seat Temperature Sensor - G95- and Right Rear Seat Heating Element - Z12-
❑ Not all vehicles have heated seats (optional equipment, seat ventilation is not planned as optional equip‐
ment).
❑ The activation of the seat heater is displayed in measured value block of Rear A/C Display Control Head
- E265- . Use the Vehicle Diagnostic Tester via the "Guided Fault Finding" function.
❑ For repairing the seat heater, refer to ⇒ Body Interior; Rep. Gr. 74 .
❑ On vehicles with the seat occupied recognition system, rear seat heater may be switched off after ap‐
proximately 10 minutes by the Rear A/C Display Control Head - E265- if recognized that seat is
unoccupied. Use the Vehicle Diagnostic Tester via the "Guided Fault Finding" function.
Note
The activation of seat heating differs
on vehicles with or without a Rear A/
C Display Control Head - E265- .
Refer to Wiring diagrams, Trouble‐
shooting and Component locations.
18 - Left Rear Heated Seat Temperature Sensor - G94- and Left Rear Bench Seat Heating Element - Z10-
❑ Not all vehicles have heated seats (optional equipment, seat ventilation is not planned as optional equip‐
ment).
❑ The activation of the seat heater is displayed in measured value block of Rear A/C Display Control Head
- E265- . Use the Vehicle Diagnostic Tester via the "Guided Fault Finding" function.
❑ For repairing the seat heater, refer to ⇒ Body Interior; Rep. Gr. 74 .
❑ On vehicles with the seat occupied recognition system, rear seat heater may be switched off after ap‐
proximately 10 minutes by the Rear A/C Display Control Head - E265- if recognized that seat is
unoccupied. Use the Vehicle Diagnostic Tester via the "Guided Fault Finding" function.
Note
The activation of seat heating differs
on vehicles with or without a Rear A/
C Display Control Head - E265- .
Refer to Wiring diagrams, Trouble‐
shooting and Component locations.
19 - Rear A/C Display Control Head - E265-
❑ Versions vary (for vehicles with or without seat heating. For allocation, refer to the Parts Catalog.)
❑ Removing and Installing. Refer to
⇒ "9.48 Rear A/C Display Control Head E265 , Removing and Installing", page 190
❑ If the child safety system is active in the vehicle, the Rear A/C Display Control Head - E265- does not
permit the setting of rear A/C system and seat heater to be modified (when button or rotary switch is
178
Rep. Gr.87 - Air Conditioning
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.
.